ELECTRIC RETRACTS

Showing all 4 results

Showing 1 – 4 of 4 results Showing all 4 results Showing the single result No results found
Sort by Popularity
Filters Sort results
Reset Apply
For use with our Pro-Drive retracts and Pro-Brake electro-magnetic braking system, our Basic gear control module offers 3 gear cycling, fully proportional electric brake control and steering servo control. Intuitive programming makes setup a breeze. Includes. Specs:.
$82.95
Buy here
Max: 4
Min: 1
Step: 1
Add to cart
PL-LGC12S
Jeti Model AFC Anti-Spark Connectors 4mm
Jeti AFC Anti-Spark Connectors 4mm The Jeti Model AFC connectors eliminate the flashes often witnessed when connecting controllers (ESCs) and battery packs. Available in 4mm, 5.5mm and 8mm variants the...
$17.00
Buy here
Max: 8
Min: 1
Step: 1
Add to cart
JMS-ASC4
Controller for electric landing gear, brakes and doors. -Direct control of 3 motors in bidirectional mode up to 12V/5A. Supports the different motor shut-off control types currently available (time, overcurrent and encoder). -Dual control of electric brakes, full proportional, lineal and adjustable pulsed mode. -Differential brake mode, to steer the model using the brakes. -Steering servo processor. Gain, sense and center can be adjusted. The steering servo is centered during retraction. -Internal Gyro. It can be mixed with the steering servo output and mixed to the differential brakes. -8 servo outputs for the control of the doors. The endpoints of each servo can be programmed individually. The Servo speed can be programmed independent in the two senses in 0,1s resolution. -10 step sequencer. The position of the gears and the position of the 8 doors can be defined independent in each step. Step duration resolution in 0,1s steps. -Wide choice of RC inputs. Single RC channel, Dual RC channel, Futaba SBUS, UDI Bus, SRXL Bus, JR Mode A Bus, JETI EX Bus. -Programmable trough integrated color touchscreen. -uSD card slot to save the settings and upgrade the software. User's manual: http://www.xicoy.com/LG15.pdf. Important Note: This controller is set up to be used with Pro-Link Taurus, Hercules, and Genesis Retract systems meaning 2.0 Amp motor cut-off, 9 sec. Time, and .01sec Unload. If other parameters are needed the controller must be preprogrammed by the manufacturer. .
$192.95
Buy here
Max:
Min: 1
Step: 1
Add to cart
PL-LGC15
Pro-Drive Taurus Series T-Bar. Direct Replacement for Pro-Drive Taurus Series Electric Actuator. M4 Thread.
$9.75
Buy here
Max: 10
Min: 1
Step: 1
Add to cart
TRE-605