Emcotec SPS Safety Power Switch 70V 100/200A


SPS SafetyPowerSwitch 70V 100/200A

Out of stock

Email when stock available

SKU: EMC-A72011 Category: Tag:


SPS Safety Power Switch 70V 100/200A

-SPS Gas Cap Actuator Connector Type

SPS Safety Power Switch 70V 100/200AElectronic safety power switch for electric power systems. An anti-flash-circuitry prevents the sparks during connecting the battery.

The SPS Safety Power Switch separates the motor from the battery. The electric motor drive remains inactive and therefore non hazardous until activation.

High-class silicone connection cable of 4mm² (AWG11) thickness. 6-fold multilayer-board with up to 9mm² copper width.

For 6S up to 16S LiPo batteries (18V to 70V). 100A continuous current and 200A peak current – perfect for F3A models.

Attention: The flash protection function of the SPS does not pre-charge the capacitor within the motor controller! Some manufacturers require the pre-charging of this capacitor. Perhaps the SPS might not work properly in this special case.

Attention: The total capacity of all capacitors inside the ESC including additional capacitors must not exceed the value of 1500µF. In case of doubt ask the ECS’s manufacturer.

NOTE: Please see note for charging ESC capacitors in Download section.

NOTE: When using the following Graupner products the galvanic isolation of receiver and drive circuit is not possible. So the SPS Safety Power Switch cannot be used with these modules:

    Electric Air Module2-14S, Vario HoTT (Item no. 33620)
General Engine-Module 2-6S Gr. HoTT (Item no. 33610)
General Air-Module 2-6S, Vario Gr. HoTT (Item no. 33611)
Voltage Module 2-4S, EH (Item no. 33630)
Voltage Module 2-4S, XH (Item no. 33631)

Delivery includes switch actuator with keyring pendant or SPS-RCS, screws and operating instructions.


  • Suitable batteries (LiPo)  6S …16S LiPo
  • Voltage range  18V … 70V
  • Current consumption  max. 0.5mA, typ. 0.25mA
  • Permanent current  100A
  • Maximum peak current  200A
  • Verlustleistung bei 100A  approx. 7.3W
  • Dimensions  65 x 30 x 16mm (2.56 x 1.18 x 0.63in)
  • Weight  71g (2.5oz)

Additional information

Weight 0.2 lbs