Pro-Link Landing Gear Controller – Pro

Description

For use with our Pro-Drive retracts and Pro-Brake electro-magnetic braking system. Our feature packed “PRO” system control module offers a host of exceptional features not availble in our “Basic” module.

PRO Features:

-Control by Single channel (Gear operation and brake operation combined on single channel) or separate channels for gear and brake.

-Control 3 landing gears. Programmable independent delay for each gear in UP and DOWN sequence.

-Control of electric brake:

•  Proportional and adjustable maximum brake force
•  Continuous operation or pulsed mode for “ABS” effect, 10 levels of pulse ratio.
•  Brake Limiter to set max brake force

-Control of steering servo

• Allow to use same channel as the rudder despite different center, independant travel gain and direction on steering servo from rudder servo. The steering servo center, travel and sense of movement can be adjusted.
• The steering servo is centered and deactived during gear operation and gear UP phase.

-Door control output:

• 3 independent servo outputs for door control.
• Each output can be programmed in 3 different positions (Gear UP, Gear Down and Gear Moving phase).
• Servo Switch-off. Door servos can be deactivated after movement to prevent the posibility of servo burnout on a jammed door. Deactivation time can be programmed.

-Manual mode:

• Provides the ability cycle the gear manually for testing during setup phase, movement can be stopped and reasumed in any position.
• Each drive motor can be independently run in any direction and stopping in any position for checking clearance, etc.

-Motor Log:

• Cycle counter for scheduled maintenance.

-Easy setup:  All adjustments are done through a Xicoy data terminal.

-Electronic switch for the main battery.

Note:

•  The unit can be programmed using the onboard LED and switch like our Basic controller (options limited using this program method)
•  Data terminal for full programming not included. Compatible with all Xicoy SBus style data terminals used with Xicoy brand ECUS.

Specs:

• Cut Off Amperage – 2.1A
• Operating Voltage – 6V to 10V

Includes

• “PRO” Sequencing Control Module
• Three Male-Male Module to Rx Leads
• Instruction Manual

Specs:

• Cut Off Amperage – 1.5A
• Operating Votage – 6V to 10V