SECRAFT V3 Hitec 1″ Servo Arm M3 – Blue


SECRAFT V3 Hitec 1″ Servo Arm M3 – Blue.

4 in stock


SECRAFT V3 Hitec 1″ Servo Arm M3 – Blue 

SECRAFT Precision Machined Heavy Duty Aluminium 6061-T6 (anodized) 1″ Servo Arm for Hitec.  Designed to clamp around the servo shaft and compensate for inconsistancies in the output shaft sizes.
Half arms are measured from the servo screw hole to the outside hole.

Hitec: 24T(blue)
Length :1.0inch(25.4mm)
Fixing screw bolt is M3
Weight: 3.5g
1 Per package


Installation Guide

– Follow aircraft manufactures recommendation for Servo control horn set up.

– LockTite all servo screws.

– Install ball link on bottom of servo arm (where possible).

– Keep all linkage tight.

Note: SECRAFT servo arms should fit snug, and not just slip onto the output shaft. In fact they should go on about a 1/3 of the way with light pressure and use the screw to pull them down the rest of the way. We do this because we are all after the tightest linkage and if there is any play in the spline fit it will only get worse. If need be, place a drop of light oil in the servo arm hole being very careful not to get any oil in the servo screw hole to help get the arm in place. Remember oil in the servo screw hole will not let the Loctite work properly. We suggest the arm’s be installed outside the aircraft and on a stable flat surface.

Additional information

Weight 0.01 lbs