UniLight 16Wx2 Flashlight, 11mm, SHORT, T-Fuse – Green
Powerful flashlight in x2 technology – extreme light output! The profile of 11mm light series is externally very slim design and fits optically to smaller models. By x2 performance especially for large models a real eye-catcher. This light only suitable for short flash or flashing mode. To ensure the operational safety of light and model, is located on the underside of the unit an overtemperature protection. If the lamp thus operated for too long and thus become too hot, this switch will turn off the light. To increase the service life of this function must not be used permanently!
The luminaire is fully assembled for use with 2S LiPo (about 8V). Check after installation the operating temperatures.
Electrical: 16Wx2 reference power, 8 (12) V, 1.4A
Angle:> 160 °
Aperture: 2×200 Lumens RED
Aperture: 2×400 lumens WHITE
Dimensional light cap: 11.5×42.5x10mm until 4mm sunk without loss of the radiation angle
Overall dimensions: 11.5x70x10mm
Weight: 8g (without cable)
Delivery: with 1m silicone cable and pre-assembled ready for 2S resistor operations
With the X2 technique high power LEDs are operated in a “cluster”. These achieve double the light output for the same heat or the same light output at half heat dissipation. Yet our X2 lights are still fully compatible with all our other lamps. If X2 lights, such as spotlights, are supplied with separate cables, these cables must be used in the delivered wiring! X2 lights are reacting more strongly on a weakening battery.
The reference power is a comparison value between our offered lights. It normally refers to an operating voltage of 12V/3S Lipo and is dependent on bulbs, operating mode and technology.
Pay always attention to the operating temperature, we do not assume any warranty in case of overheating.
Note: The LED lights are extremely bright! Never look directly into a LED!