3Wx2 Navigation & Strobe, Short, 7mm Green/White
Thumbnail positioning and flashlight in one housing. The profile light 7mm series is externally very slim and fits optically on kleinse models. But through thanks to new LED emitter has a high light output despite the micro-dimension, the compact design permits operation even on the smallest models. The novel, shifted inwards cooling surface allows astonishingly compact dimensions with unique slim design.
The luminaire is fully assembled for use with 2S LiPo (about 8V). During operation with 3S (12V) of the enclosed resistor must be used. Please note that high-power LEDs can be very warm, up to 70 ° C is quite normal. These luminaires with heatsink enclosures are suitable for the model operations when an air flow is possible (in flight). If this is not the case, then switched-on durations of 5-10 should not be exceeded. Check after installation the operating temperatures.
Electrical: 1wx2 RED / GREEN and WHITE 2Wx2 reference power, 8 (12) V
Angle:> 150 °
Aperture: ~ 40 lumens RED, 0.12A
Aperture: ~ 50 lumens GREEN, 0.12A
Aperture: ~ 110 lumens WHITE, 0.17A
Dimension Cap: 19x8x6
Dimensions cooling pin: D7x15
Weight: (without cable)
Delivery: enclosed with 2×0.5m Teflon cable and pre-assembled ready for 2S series resistance, resistance for 3S
The reference power is a comparison value between our offered lights. It normally refers to an operating voltage of 12V/3S Lipo and is dependent on bulbs, operating mode and technology.
Pay always attention to the operating temperature, we do not assume any warranty in case of overheating.
Note: The LED lights are extremely bright! Never look directly into a LED!