4W position light, 11mm – RED
Budget position / navigation light of 11mm series is externally very slim design and fits optically to smaller models. The profile-shaped polycarbonate cap is plugged on delivery. This can be painted separately.
The luminaire is fully assembled for use with 2S LiPo (about 8V). During operation with 3S (12V) of the enclosed resistor must be used as an alternative you can also use a 4W-3S adapter cable. Please note that high power LEDs can be very hot, up to 70 ° C is quite normal. These luminaires with heatsink enclosures are suitable for continuous operation, when an air flow is possible (in flight). If this is not the case, then switched-on durations of 5-10 should not be exceeded. Check after installation the operating temperatures.
Electrical: 4W reference power, 8 (12) V, 0.35A
Angle:> 160 °
Aperture: 50 Lumen RED
Aperture: 80 Lumen GREEN
Aperture: 100 lumens WHITE
Dimensional light cap: 11.5×42.5x10mm until 4mm sunk without loss of the radiation angle
Overall dimensions: 11.5x70x35mm
Weight: 8g (without cable)
Delivery: enclosed with 1m silicone cable and pre-assembled ready for 2S resistor operation and resistance for 3S
The reference power is a comparison value between our offered lights. It normally refers to an operating voltage of 12V/3S Lipo and is dependent on bulbs, operating mode and technology.
Pay always attention to the operating temperature, we do not assume any warranty in case of overheating.
Note: The LED lights are extremely bright! Never look directly into a LED!