UniLight Profile Light Ultra, up to 20Wmax, T-Fuse – White

Profile Light Ultra, up to 20Wmax, T-Fuse White. Profiled ultra high-performance spotlight with up to 20W flash power, 14W continuous output and very good beam angle through a special spreading cap. An unprecedented luminosity of 900lm in continuous operation with minimal dimensions. The perfect flash and position light if you want your model to be seen in all weathers and in any position! It's the most powerful light in our program. Unfortunately, pictures in the switched on state are practically impossible with this light. The luminaire is delivered as a ready assembled unit on an aluminium cooling plate and a changeable polycarbonate cap as covering. The luminaire is ready to use for 3S Lipo (12V) operation. This extremely powerful luminaire can only be operated continuously if it is sufficiently supplied with cooling air (mounted outside on the surface). For the protection of the luminaire, a temperature limiter is integrated on the backside, which switches off the lamp in case of overheating or temporarily interrupts it in order to ensure the cooling down. During flash mode, the heat causes no problems and the luminaire can be recessed. Please note that high-performance LEDs can get very hot, up to 70°C is quite normal. This extremely powerful luminaire overheats within 1 minute without air cooling, thus being switched off internally. For continuous operation, mount the luminaire on the surface of your model, so that the airflow can flow past the cooling plate. Attention: Do not look into the light from a close distance! Even indirect exposure from a close distance will lead to glare!. . Technical Data. Electricity: 14W reference power, 12V, 1.1A. Beam angle: >160°. Overtemperature protection: switch-off and clocking of the light at 65-70°. Light intensity: 600 Lumen/2S RED. Light intensity: 800 Lumen/3S GREEN. Light intensity: 900 Lumen/3S WHITE. Dimension: 24x56x9mm. Dimension base panel: 2mm. Temperature sensor bottom inside: 2mm. Weight: 13g (without cable). Delivery: ready to use with 1m connection cable. RED version with additional series resistor for 3S (12V) enclosed. GREEN and WHITE only useable with 3S (12V). The reference power is a comparison value between our offered lights. It normally refers to an operating voltage of 12V/3S Lipo and is dependent on bulbs, operating mode and technology. Pay always attention to the operating temperature, we do not assume any warranty in case of overheating. Note: The LED lights are extremely bright! Never look directly into a LED!.